SkullandBonesSkateboards.com Forum Index » SCREEN PRINTING » Screen distance...does it have to be 1/8"? |
Page 1 of 1 |
|
Author |
Message |
Nick |
Posted: Mon Jul 07, 2003 12:11 am |
|
|
Joined: 13 Apr 2003
Posts: 260
|
Ok, I built up my frame and stretched the mesh. But the mesh doesnt conform perfectly with my boards. So in order to get the center of the deck 1/8", the curve of the nose and tail push against the mesh. There will be a graphic in the spot. I could raise the screen but then it will be about 1/2" off the center of the board... What are some downsides of having the screen to close or too far from the deck? |
|
|
Back to top |
|
|
donald20 |
Posted: Mon Jul 07, 2003 11:49 am |
|
|
Joined: 01 Aug 2002
Posts: 1075
Location: germany
|
with more practice given you'll also be able to go higher on the distance you have.
just make sure you don't do the printing with sheer power.your fingers have to bend the squee correctly.the rest is just a flowing motion |
|
|
Back to top |
|
mr black |
Posted: Mon Aug 11, 2003 5:06 pm |
|
|
Joined: 10 Aug 2003
Posts: 13
|
Nick ......sounds like you are haveing trouble .well i have printed full boards with no off contact and it worked fine ...there is just a certian way to do it ...........black |
|
|
Back to top |
|
|
Nick |
Posted: Mon Aug 11, 2003 10:48 pm |
|
|
Joined: 13 Apr 2003
Posts: 260
|
Yeah, i am printing boards now. I understand all this more now. |
|
|
Back to top |
|
|